|
Recommended accessories
The fitting is made from extremely hard plastic and is for anyone who wished to make their system truly High-Flow! It has an extremely large inner diameter of almost 1cm! It also has a short G1/4" thread, making it compatible to Koolance and Mips products without the use of spacer rings. Technical details: Outer diameter: 13mm Inner diameter: 10mm Thread size: G1/4" Thread length: 4,5mm Length (without thread): 28mm Extent of delivery: 1x 13mm (1/2") barbed fitting G1/4" - extreme Highflow (o-ring) Note for watercooling beginners: The connectors for imperial hoses(7/16", 3/8", ½") are provided with measurements in mm in our shop. These can differ by +-1mm, which is no problem as hose clamps have to be used for installation. If the hose is to be mounted without a clamp, a larger fitting should be chosen. With some fittings that tend to be larger, it is possible though that a hose with an inner diameter of 13mm actually does seal without a hose clamp. Overview: 10mm (3/8") hose clamp: up to 8mm none, from 10mm up required 10mm (7/16") hose clamp: up to 8mm none, from 10mm up required 12mm (1/2") hose clamp: up to 11mm none, from 12mm up required 13mm (1/2") hose clamp: up to 11mm none, from 13mm up required
This product will be shipped, unless otherwise specified, without a printed manual. For questions regarding the installation of the product, please contact our support. |
|
