|
Manufacturer's ID: MCH2071
Recommended accessories
Description
With immediate effect we now also offer newly developed cooling solutions for different RAID controllers! This RAID controller waterblock was specially designed for the following controllers: - Adaptec RAID 5405 Series These controllers are only cooled with a small passive heatsink which will run very hot depending on the load of the controller. As the card is basically mounted "heads down" natural convection is reduced to a bare minimum, hence requiring active airflow. But in a watercooled PC this airflow is often lacking. Hence this waterblock is the perfect expansion if you are already using a watercooled system. IMPORTANT: The de-installation of the stock chipset cooler may void your warranty, please work accordingly careful when mounting this product. The included spacer rings are necessary for installation if the thread length of your fittings is more than 4mm. If you do not use the spacer rings the fittings will push the waterblock open, resulting in a leak! We are not responsible for any damages resulting from or during installation of this product and will not be liable. Tipp: Adaptec uses a thermal glue on their waterblocks and additonally secures the heatsink with a plastic clip. Please first remove the clip and afterwards carefully heat the heatsink (hairdryer or similar) and remove the heatsink from the controller chip. Possible residues of the thermal glue can be removed with cleaning benzine or similar before mounting of the waterblock. Please use non-conductive thermal compound such as the Arctic Cooling MX series when mounting this product! Please note that due to design reasons you will loose at lease one more slot! (angled fittings etc.) Please note: Our waterblocks are always shipped without fittings, please order fittings separately if needed. This product will be shipped, unless otherwise specified, without a printed manual. For questions regarding the installation of the product, please contact our support. |
|
